Steering rod set for Audi (B2, B3, B4) Coupe, Quattro, 80/90/Coupe, S2/RS2, etc. 25 mm think tubing like in B Group times to provide strong and precision car handing in the corners under extreme loads.

Rods can be adjusted to fit any suspension settings including longer Audi Sport wishbones.

Motorsport tie rod ends will withhold any stress while the car is on the track or bumpy gravel road. Locknuts on every end of the stick will enable precision alignment of the suspension.

All non-OEM parts necessary for the installation are supplied in the kit.

Whats Included:
One set (two pieces) of front track rods with inox finish
Four motorsport tie rod ends
Steel machined tie rod end adapters to fit to stock uprights (B3/B4 type)
Self-locking nuts
Four rubber sealing boots

Features:
Works with stock OEM or Audi Sport wishbones
25 mm thick steering rods powder painted in black
Inox screws for 22 wrench from each side
Locknuts for securing the motorsport joints
Galvanized tire rod end adapters for fitting bearing carriers

Fits (does not fit cars with 10VT engines) :
Audi 80 B2 (FWD & Quattro)
Audi 80/90 B3 (FWD & Quattro)
Audi 80/90 B4 (FWD & Quattro)
Audi S2
Audi RS2
Audi Ur-Quattro with B3/B4 uprights
Audi Coupe Quattro

It will not fit:
Audi Ur-Quattro 10vt
Audi Ur-Quattro 20vt

Notice: Some clearance of the steering rack bracket may be necessary to prevent binding or interference, depending on your suspension settings. Usually not needed unless you have a large caster setup.